Speakon hole size?

Message

mjm · #1 Post by **mjm** » Tue Jan 15, 2008 8:11 pm

I ordered Neutrik NL4MP Speakon 4 Pole Panel Mounts. While I am waiting for them to arrive could anyone tell me what size hole needs to be drilled to mount them?

Thanks Mike

dbaldock · #2 Post by **dbaldock** » Tue Jan 15, 2008 9:10 pm

Hello Mike,

The Neutrik web site has all the Tech info for the Speakon® Lockable Loudspeaker Connector / Chassis Connectors.

Take Care,
David Baldock

DJPhatman · #3 Post by **DJPhatman** » Tue Jan 15, 2008 9:17 pm

23.6mm or just shy of 1 inch. Info from http://www.partsexpress.com/tech/092-052.html

LelandCrooks · #4 Post by **LelandCrooks** » Tue Jan 15, 2008 9:19 pm

15/16

mjm · #5 Post by **mjm** » Tue Jan 15, 2008 10:17 pm

Thanks guys that is the info I needed.

Mike

gdougherty · #6 Post by **gdougherty** » Wed Jan 16, 2008 9:53 am

If you need two on the cabinet (I always do) this little puppy from PE is a great way to install them. All you need is a 3" hole saw, the back side has a 3" circular ring that fits right inside and a bit of caulk and 4 screws fix it in. You do need some small bolts to mount the speakon connectors but they're fairly cheap. Can't find them, but I'd picked up a bag of 100 and another of 100 nuts at PE a while back.

http://www.partsexpress.com/pe/showdetl ... er=262-348

fender3x · #7 Post by **fender3x** » Wed Jan 16, 2008 12:55 pm

Of course, for those of us who are less precise... 1" I haven't yet put one where it needs to be sealed. But when I do... 1" and a little hot melt glue around the edge