LaVoce WSF081.82 for the 8" and Eminence ASD1001B compression drivers. I think they'll be a good fit
Right now I have a t39 and t30 in my shop. Not what I was going to use, more like a 20" wide Tuba 24 with 10" drivers
DR200 Kent's build
-
KentWhitten
- Posts: 14
- Joined: Sat Jan 18, 2025 11:02 am
- Location: East Waterboro, ME
-
KentWhitten
- Posts: 14
- Joined: Sat Jan 18, 2025 11:02 am
- Location: East Waterboro, ME
Re: DR200 Kent's build
Finally got everything on the inside pre-painted and the sides are on. You can see that I went with the option to use the cutouts from the top and bottom "boob" half round pieces for a lack of better term. I was honestly quite surprised as to how well they came out. I fully expected a large hump where everything meets up, but was pleasantly surprised.
The pair of them all wired up through the back side and durhams wood putty filler
-
KentWhitten
- Posts: 14
- Joined: Sat Jan 18, 2025 11:02 am
- Location: East Waterboro, ME
Re: DR200 Kent's build
Back was prepped with hand holds and speakon holes, installed, trimmed, glued and screwed on the back panel. One thing I regret was not taking the time to figure out how to recess those speakons quickly and easily. After I mucked it up, I found out how to do it . Oh well, there's always next time.