As I will have to mix T-nuts and screws to mount the driver in the Jack I found these at Woodcraft and while
I've searched the forum I haven't found these mentioned. $3.99 for 50 1 1/4 ". Kreg packs were all $16 or more for 100 min. Seems like they'll do the job.
http://www.fastcap.com/estore/pc/viewpr ... duct=13284
Can you all see any reason why not?
Could I use them all the way 'round and skip the T-nuts for a Deltalite?
Driver mounting screws
Driver mounting screws
2X Tuba 24 HL10c
2X Omni 12
2X DR 250
Omni 10
6X Wedgehorn 6
2X Jack 10
2X Omni 12
2X DR 250
Omni 10
6X Wedgehorn 6
2X Jack 10
-
Rune Bivrin
- Posts: 521
- Joined: Tue Aug 19, 2008 5:42 pm
- Location: Stockholm, Sweden
Re: Driver mounting screws
I would recommend screws all around for any NEO driver. Particularly in the Jacks and OTops where there are no issues accessing the screws. T-nuts and bolts are overkill (but overkill is never wrong 
)
)In build order:
O12 with no tweeter.
3 x WedgeHorns.
2 x Jack 10 without tweeters.
2 x DR250.
2 x 16" T39
1 x Tuba 24
2 x SLA Pro (sort of...)
O12 with no tweeter.
3 x WedgeHorns.
2 x Jack 10 without tweeters.
2 x DR250.
2 x 16" T39
1 x Tuba 24
2 x SLA Pro (sort of...)
Re: Driver mounting screws
When I did finally use them they were wonderful!
Went in like "butta" and held on like grim death!
Certainly the quickest driver mounting I've ever done
Went in like "butta" and held on like grim death!
Certainly the quickest driver mounting I've ever done
2X Tuba 24 HL10c
2X Omni 12
2X DR 250
Omni 10
6X Wedgehorn 6
2X Jack 10
2X Omni 12
2X DR 250
Omni 10
6X Wedgehorn 6
2X Jack 10