Piezo Crossover Question

Anything not covered elsewhere.
Post Reply
Message
Author
groig
Posts: 33
Joined: Tue Sep 30, 2008 10:33 am

Piezo Crossover Question

#1 Post by groig »

My TLAH is a bit bright with the piezos. I noticed in my Jack plans that the resistor can be moved to decrease sensitivity by 2 dB. Will this work with the TLAH crossover as well? I realize the two crossovers have different corner frequencies. Also, is there a simple formula for adding resistance to pad piezo tweeter arrays such as if I wanted to knock them down 3 or 6dB?
Top
User avatar
Bill Fitzmaurice
Site Admin
Posts: 28916
Joined: Tue May 02, 2006 5:59 pm

Re: Piezo Crossover Question

#2 Post by Bill Fitzmaurice »

groig wrote:My TLAH is a bit bright with the piezos. I noticed in my Jack plans that the resistor can be moved to decrease sensitivity by 2 dB. Will this work with the TLAH crossover as well?
Yes.
Also, is there a simple formula for adding resistance to pad piezo tweeter arrays such as if I wanted to knock them down 3 or 6dB?
No. If it's still too bright after moving the 4 ohm resistor you should be using EQ for further adjustments. For that matter you should have tried that option already.
Top
Post Reply

Return to “Everything Else”