Paint for Plastic Piezos?

[loudsubz]

Would model paint work for touching up the piezos? When I glued mine together some glue came out between the joints so I sanded it off and there is some spots that look a little rough and I would like to touch it up. Not sure what is best to stick to the plastic.

[Michael Ewald Hansen]

Would model paint work for touching up the piezos? When I glued mine together some glue came out between the joints so I sanded it off and there is some spots that look a little rough and I would like to touch it up. Not sure what is best to stick to the plastic.

Model paint should be fine!

http://billfitzmaurice.info/forum/viewt ... zo#p159923

[subharmonic]

I used the rustoleum spray paint made for plastic (it has a pic of cheapo plastic lawn chair on it) followed by modelling spray paint. The rustoleum covered the spot filler way better than the model stuff, just like a primer. Did them back to back, no issues yet.

[SoundInMotionDJ]

I used the rustoleum spray paint made for plastic (it has a pic of cheapo plastic lawn chair on it)

This stuff is great. I used it on the piezos, DR port rings, and DR port tubes.

--Stan Graves

[loudsubz]

Does it also come in a small can so I can use a brush? If not it would be alot of masking or remove the elements from the piezo to paint them.

[subharmonic]

Spray paint. I tested on miscut piezos. Barely a trace made it past the phase plug.

[loudsubz]

Ended up using speaker cloth instead. Found some on sale and used a piece of corner molding to keep it taught. Had the wife sew the ends of the fabric on the top and bottom so it looked nice and wont fray.

I still need to paint the white molding black, but I think it looks ok.

[Tom Smit]

It sure does look OK!

[doncolga]

I like the cloth covering ALOT. I've seen a piezo stack for OT15's like that. I may do that with mine eventually.

[J_Dunavin]

Really like that!

[Drey Chennells]

Nice. The cloth grill lends a different feel. I've had some requests for cloth over the 8mm round steel we normally use.

DR250 039_phixr.jpg

Inkspot Grill.JPG

[AntonZ]

I like the look of the cloth over the piezo's, well done.

[loudsubz]

All painted up now, just waiting for the duratex

[Drey Chennells]

Really nice!