Handle holes in Titan 39

Helpful hints on how to build 'em, and where to get the stuff you need.
Post Reply
Message
Author
User avatar
KevinR
Posts: 13
Joined: Mon Aug 15, 2011 10:36 pm
Location: Fairmont, WV
Contact:
Contact KevinR

Handle holes in Titan 39

#1 Post by KevinR »

I'm not clear on the suggested handle hole size for the Titan 39...

As stated in the instructions...
"The easiest way to cut hand holds is to drill two 1½ inch holes four inches apart on-center"

So my question is... Is this correct? (as noted in the attached picture)
Attachments
handle.gif
handle.gif (6.44 KiB) Viewed 683 times
USA Musicians Network (http://usamusicians.com)
West Virginia Musicians Network (http://wv-music.com)

Current build:
Titan 39x24 (pair)
Top
User avatar
Jon Barnhardt
Posts: 718
Joined: Wed Jun 08, 2011 1:20 pm
Location: Bismarck, ND - Licensed builder
Contact:
Contact Jon Barnhardt

Re: Handle holes in Titan 39

#2 Post by Jon Barnhardt »

yes
Top
Post Reply

Return to “Tips, Techniques and Supplier Links”