Jack 12 review

[cheapbasslovin]

Look Harley, I already have my Jack plans. I almost have my garage cleared out enough to build a couple without killing either myself or the cabinet. I'm having enough trouble figuring out which Jack configuration to go with. I don't need anyone successfully convincing me that a DR and a sub is the way to go now. Blarrrgh

I only need a couple of Jacks. I only need a couple of Jacks. I only need a couple of Jacks.

[DJPhatman]

Any of you bass nerds using a single 110/112 with the little kickstand that Leland sells?

I have Bill's prototype, with the "kickstand" and I am adding a melded array and filters with an all on/alloff by-pass switch. IOW, when the tweeters are on, the filters are used. When switched off, the filters are by-passed.

[bzb]

Any of you bass nerds using a single 110/112 with the little kickstand that Leland sells?

I have Bill's prototype, with the "kickstand" and I am adding a melded array and filters with an all on/alloff by-pass switch. IOW, when the tweeters are on, the filters are used. When switched off, the filters are by-passed.

Any other feet or anything on the bottom, or just the rubber caps on the kickstand? Wondering if it stays put on something like a hardwood stage, or if you need the other rubber feet on it. Also, is the angle enough to get the sound up at you?

[DJPhatman]

The hard rubber feet Leland sells. The kick-back is not as severe as you thing. I keep my 6RU plastic SKB case on top with the cab tilted, but it is strapped on. Once the composite one is done, I'll post a review from bass players who don't know who Bill Fitzmaurice is. I will really try for video with sound when they get the 1st listen. On my floors, the cab does not move, and I did have it cranked pretty high. Most everything in the house was vibrating and rattling, except the cab!

[bzb]

Very nice. How close is the composite one to being done?

My only luck with getting good sound from a camera mounted mic has been using a shotgun condenser mic on my Sony shoulder mount. The problem there is outdoors, the condenser picks up way too much wind noise, and it's hard to edit out.

Typically, I just use my little P&S Canon SD780 to take my videos and the mic is pretty good as long as you're far enough from the cabs, or you don't have them cranked to 11.

[Monomer]

Very nice. How close is the composite one to being done?

All panels are cut, and the resin just show'd up in the mail today. Expect assembly photos soon.

[DJPhatman]

All panels are cut, and the resin just show'd up in the mail today. Expect assembly photos soon.

Finally!