Setting up the BBE DS48 (pictures) any comments/help thanks!

[loudsubz]

Just got around to setting up my new DSP.

I am running 2 X Titan 39 (3012LF Loaded) and 2 X Otop 12 (Delta Pro 12a) Loaded

Here is the setup I have thus far.

Initial Setup. I have Channel A and B as the 2 main inputs from my mixer. Out 1 and Out 2 are for the Otops. Out 3 and out 4 are summed for my Titans.







My Top Corssover


My Sub crossover


Delay (I put 7ms but wasn't sure what to play around with)


Gains are all 0


Limiter I left default but need to fix that


Last we have the PEQ, I wasn't sure what to tweak there.

[Monomer]

Looks alright.

Crossover settings will change per room. Acoustic vs. electric. (covered elsewhere)

I usually have one single sub out, and run the amp in parallel output, less wiring.

[loudsubz]

Thanks.

What about the PEQ setting? Is it something that should be tweaked by ear after listening? I know for the GEQ its suggested to do the opposite of the response graph than do some slight tweaking by ear after.

[Tom Smit]

Probably pretty much the same way. And you can use the Q to widen or narrow the width of cut/boost.