Cabinet edge trims?

Message

Kaptain John · #1 Post by **Kaptain John** » Fri May 30, 2008 12:25 pm

Hey everybody~
I'm close to having the DR250/Tuba setup completed. Does anybody have any recommendations for the trimming the edges? There seem to be lots of options for corner protection, but I haven't seen much in the way of protecting the edges. I was thinking of a nice plastic or aluminum extrusion to go down each edge.
Thanks!

gdougherty · #2 Post by **gdougherty** » Fri May 30, 2008 1:11 pm

I don't bother since that's not something you usually see on professional cabinets. I do the interlocking plastic corner protectors for protection and to help the cabs stack together, but otherwise I roundover the corners with a router and coat the whole deal in Duratex.

vlad335 · #3 Post by **vlad335** » Fri May 30, 2008 1:28 pm

I used these.
http://www.realproaudio.com/product_inf ... cts_id/666