Grant Bunter wrote: ↑Thu Nov 24, 2022 1:17 am
Very tidy, good work!
One thing I did to keep it clean was for the smaller horn sheaths. My concern was smearing all of the PL from the sides onto the larger sheath in all of the wrong places so I only glued the the leading edge, trailing edge and the throat sheath brace supports for the clamp up. Once the PL dried/ cured, I went back taped off the the sides and squeezed the PL in the sides.
After all that, I noticed that the PL was appeared a little porous in a few spots so I went back over all of all of the sheath's PL joints with bondo just to make sure they're air tight. Rasps and files made quick work of the bondo

.
So far this thing is a beast. I sat on it just to test the strength and its solid.
After Its done I'll attempt to weigh it on bathroom scale.