Page 1 of 1
J-Array brackets for 4 cabinets in each array
Posted: Mon Jul 13, 2015 5:39 pm
by vesthardt
Hello!
I can't figure out from looking at the plans how to setup the brackets for 4 cabinets per side in the J-array. Anyone who can help me understand?
Thanks,
vesthardt
Re: J-Array brackets for 4 cabinets in each array
Posted: Mon Jul 13, 2015 6:14 pm
by Bill Fitzmaurice
Look at your Sketchup. Four is the same as three, with one more added to the pile.
Re: J-Array brackets for 4 cabinets in each array
Posted: Tue Jul 14, 2015 1:36 am
by vesthardt
So the extra cab should just be same angle as the top one without spacing between them?
Re: J-Array brackets for 4 cabinets in each array
Posted: Tue Jul 14, 2015 6:47 am
by Bill Fitzmaurice
The angles that the cabs are set at depends on your installation. That's why there are multiple holes in the brackets, so they can be set as required.