Page 1 of 1
General Bracing Question
Posted: Tue Feb 18, 2014 10:21 am
by tpgreen
Is it a problem when the outermost brace at least partially blocks the driver from the outside panels?
In other words consider the attached image. Basically the solid outermost braces constricts the expansion(except to the rear/front).
Thanks,
tom
Re: General Bracing Question
Posted: Tue Feb 18, 2014 11:25 am
by Bill Fitzmaurice
tpgreen wrote:Is it a problem when the outermost brace at least partially blocks the driver from the outside panels?
No, the wave will go around them.
Re: General Bracing Question
Posted: Tue Feb 18, 2014 12:14 pm
by escapemcp
That's a big effin' speaker you are making there
Please post a build log as you go
Re: General Bracing Question
Posted: Tue Feb 18, 2014 12:33 pm
by tpgreen
escapemcp wrote:That's a big effin' speaker you are making there
Please post a build log as you go
Actually, this is a big effin speaker - a dual 12", 39" T60.
Putting the THT together feels like assembling a bookshelf speaker after building the mighty T60.
Re: General Bracing Question
Posted: Tue Feb 18, 2014 1:43 pm
by escapemcp
tpgreen wrote:escapemcp wrote:That's a big effin' speaker you are making there
Please post a build log as you go
Actually, this is a big effin speaker - a dual 12", 39" T60.
Putting the THT together feels like assembling a bookshelf speaker after building the mighty T60.