BillFitzmaurice.info

Hello Bill,
Can I run my plan by you and get some "Feedback" from the "Expert"?
Anyway, I plan on putting a 4 x KSN1165A piezo array in my 2x15 Kappalite 3015 bass cabinets. My question is do you think my "Simple" planed "Crossover" sounds like a good "Crossover" for this build /or would recommend a little different design?
1. piezo mounted 2 over,2under;
2. series-parallel wiring tweeters together;
3. 8ohm-20watt wire wound resister across positive & negative termenals;
4. a 4.7UF-250 volt ployproplyene capacitor in series on the positive termenal.

Any and All Help much apperciate.

Thanks Sincerely Phillip

1) Mount them stacked, frames touching, from the top edge of the cabinet downward.

2) Yes. Parallel wire 2, then series wire the 2 sets together.

3) No. Use the piezo filter Bill has posted in the forum and plans, as it applies to all piezo arrays.

4) See #3.

Please keep in mind that this forum is to support Bill's speaker designs.

Phatman has some good advice. Although since you're new to the forum I have to recommend looking I to bills designs. Either jack or omni tb would be a good choice. Those eminence drivers would work in t48s if they are the lf version. Food for thought.