BillFitzmaurice.info

This was a HS Prom at a Car Dealership, May 18-2013. 2 DR250's and 4 T39 24" using 3012LF.

Sounds really good man. How were you setup?...I'd guess you were able to do some boundary loading?

Thanks Don. Just the DR250's about 30' apart, up about 9'. Had the 4 T39's behind the left DR250. T39's stacked "V" style, without the plate. No corner or wall loaded. Bass was plenty. Used to use the V Plate at first, then started without it, to speed setup and tear down, except when I get into bigger rooms and outside, then I will add the V Plate.

This is what I use for Camera. Not the best on the Highs, but great on the Lows.

Lastcat wrote:...DR250's about 30' apart, up about 9'.

I wanted to ask you about why you had your tops so high? Were the highs fading in and out all over the room, like they were in the video?

Lastcat wrote:This is what I use for Camera. Not the best on the Highs, but great on the Lows.

I wanted to ask you about that, the highs sounded a little harsh in the video. Apart from that I think this is a very nice and clean sounding setup.

DJPhatman wrote:

Lastcat wrote:...DR250's about 30' apart, up about 9'.

I wanted to ask you about why you had your tops so high? Were the highs fading in and out all over the room, like they were in the video?

9' is fine. On the left, it was actually over the top of a partition, you can barely see. Highs fading? Not at all, Flip Up Camera is not the best with the highs, but great with the lows.

Sounded pretty good!