Page 1 of 1
Sealing the 1/4" jack on my ot12 build?
Posted: Tue May 10, 2011 8:57 am
by mobetter
Is it ok to mount a 1/4 jack on the back. It won't be sealed if I install it, but than there's already
3 vent ports, does it matter?
Re: Sealing the 1/4" jack on my ot12 build?
Posted: Tue May 10, 2011 9:06 am
by Ken Lustgarten
IMHO just use speakon jacks. If you do install the 1/4" jack it will not be to bad as long as there is a speaker wire plugged in. If you install 2 jacks and are only using 1 I would plug the unused jack. A small box can always be built in the back to seal off the jacks.
Re: Sealing the 1/4" jack on my ot12 build?
Posted: Tue May 10, 2011 12:04 pm
by wounded horse
Why does anyone use jacks on any speaker cab? Speakons lock, are airtight and have a positive electrical connection. It's a no brainer.
Re: Sealing the 1/4" jack on my ot12 build?
Posted: Wed May 11, 2011 6:07 am
by PaulNYC
Foam earplugs to seal the 1/4" jack.