BillFitzmaurice.info

Just got around to setting up my new DSP.

I am running 2 X Titan 39 (3012LF Loaded) and 2 X Otop 12 (Delta Pro 12a) Loaded

Here is the setup I have thus far.

Initial Setup. I have Channel A and B as the 2 main inputs from my mixer. Out 1 and Out 2 are for the Otops. Out 3 and out 4 are summed for my Titans.







My Top Corssover


My Sub crossover


Delay (I put 7ms but wasn't sure what to play around with)


Gains are all 0


Limiter I left default but need to fix that


Last we have the PEQ, I wasn't sure what to tweak there.

Looks alright.

Crossover settings will change per room. Acoustic vs. electric. (covered elsewhere)

I usually have one single sub out, and run the amp in parallel output, less wiring.

Thanks.

What about the PEQ setting? Is it something that should be tweaked by ear after listening? I know for the GEQ its suggested to do the opposite of the response graph than do some slight tweaking by ear after.

Probably pretty much the same way. And you can use the Q to widen or narrow the width of cut/boost.