Page 1 of 1
Limiter set up in DRPA+
Posted: Wed Nov 03, 2010 8:37 am
by schadstr
just purchase a DRPA+ would like to know how do i set up the limiter in DRPA+ for t24's
BTW i have minimal to no knowledge on limiter/compressor ect :
Re: Limiter set up in DRPA+
Posted: Wed Nov 03, 2010 10:50 am
by Tom Smit
Oh no! Did they not ship the manual?
hint hint
Re: Limiter set up in DRPA+
Posted: Wed Nov 03, 2010 10:57 am
by schadstr
no sorry tom just stupid
like that
Re: Limiter set up in DRPA+
Posted: Wed Nov 03, 2010 11:09 am
by Tom Smit
Just so that you might be able to get "un-stoopid", here's a link to the official DBX forum.
http://www.dbxpro.com/forum/viewtopic.php?f=61&t=959 Quite a bit of reading, I know, and probably can get a bit confusing too. But slowly and surely wins the race. I can't directly answer your question because I have never operated, or even seen a DRPA+.
Edit to add the link
Re: Limiter set up in DRPA+
Posted: Wed Nov 03, 2010 2:14 pm
by SeisTres
Just know it has a compressor and a limiter, so when setting it, just make sure it is the limiter. Then it has "overeasy" which is used mostly for tops for the compression to be less noticeable. However, for the subs you want to none of that. Just plug in your amp at the setting you will have it and then measure the voltage (no speaker). You will need a voltage meter.If you do no have one and just want the amp not to clip, then you can do that instead.
Re: Limiter set up in DRPA+
Posted: Wed Nov 03, 2010 3:13 pm
by schadstr
great thanks seistres ill try tonight
