Page 2 of 2
Re: And so the addiction begins: 24" Titan 48
Posted: Thu Dec 29, 2011 7:28 pm
by Gregory East
Don't forget the bracing.
Re: And so the addiction begins: 24" Titan 48
Posted: Thu Dec 29, 2011 9:10 pm
by bass_maniac5
I have it rough cut right now but I am installing it tomorrow. (ran out of sunshine) I check for air leaks before I install the braces just so i can reach some areas in the horn.
Gregory East wrote:Don't forget the bracing.
Re: And so the addiction begins: 24" Titan 48
Posted: Sat Dec 31, 2011 9:29 am
by bass_maniac5
I had some 1x6 laying around and had run out of plywood so this is what I did
Re: And so the addiction begins: 24" Titan 48
Posted: Sat Dec 31, 2011 10:19 am
by Dan30
Nice work. Those mouth braces like beefy.
Re: And so the addiction begins: 24" Titan 48
Posted: Mon Jan 02, 2012 5:52 pm
by bass_maniac5
Dan30 wrote:Nice work. Those mouth braces like beefy.
it MIGHT be a little bit of over kill, but it is now well braced and I really like how the round-over looks. Now to clean out the shavings.
On a related note.. has anyone actually covered these with vinyl or tolex? or does everyone paint or duratex them?
Re: And so the addiction begins: 24" Titan 48
Posted: Wed Jan 04, 2012 6:28 pm
by bass_maniac5
Kitty work table...great for making precise cuts and soldering
Re: And so the addiction begins: 24" Titan 48
Posted: Wed Jan 04, 2012 6:53 pm
by Dan30
bass_maniac5 wrote:Dan30 wrote:Nice work. Those mouth braces like beefy.
it MIGHT be a little bit of over kill, but it is now well braced and I really like how the round-over looks. Now to clean out the shavings.
On a related note.. has anyone actually covered these with vinyl or tolex? or does everyone paint or duratex them?
I haven't seen any pictures of them done with vinyl or tolex but I have seen a picture where one had a grill.