Splitting my rig?

Combining subs, tops and all the rest of your kit.
Message
Author
ACUA
Posts: 539
Joined: Sun Sep 25, 2016 6:21 pm
Location: Tucson Arizona

Re: Splitting my rig?

#16 Post by ACUA »

Bought it, thanks for the heads up.
Advanced Concepts Underground Audio

User avatar
Chris_Allen
Posts: 3346
Joined: Wed Jul 11, 2007 2:43 pm
Location: Huddersfield, UK

Re: Splitting my rig?

#17 Post by Chris_Allen »

Hope it works out.
Built:
6xDR200, 2xT39, 2xT48, 2xJack110, 1xOmni10.5, 1xAutotuba, 1xT18, 1xSLA Pro, 1xW8, 1xW10

ACUA
Posts: 539
Joined: Sun Sep 25, 2016 6:21 pm
Location: Tucson Arizona

Re: Splitting my rig?

#18 Post by ACUA »

The filter components I ordered came in. I am building a little box to house them in. I had built a breakout box to help me configure a series parallel while maintaining a bi-amp config on my otop12s when I stacked them all together. This passive filter box will include that function and serve as double duty.

All the clamps to hold the box together while glue is drying.

Radian pointed out that my inductors are likely to close together. I wanted my box to be as small as possible. I hope that I did not set myself up for failure.
Attachments
46956ED5-D505-4832-985E-41C538F2C7D0.jpeg
BFF2C87F-EE99-4527-8A31-0FE6D4EFDE03.jpeg
0790C665-4312-4A19-A618-105746BBFF2D.jpeg
Advanced Concepts Underground Audio

Rich4349
Posts: 776
Joined: Wed Jul 30, 2008 10:18 am
Location: Kankakee, IL

Re: Splitting my rig?

#19 Post by Rich4349 »

Also, if they're going to be located that closely, each one should be oriented in a different plane. So one laying down, one standing up one direction, the third standing up rotated 90° from the other one standing up.
At least two of them, anyway. Someone can specify which two.
2 DR250s, 2 27" Lab15 T-60s, 2 30" Neo Titan 39s, 1 Autotuba...and looking for more!

User avatar
Tom Smit
Posts: 7323
Joined: Sat Jan 05, 2008 1:24 pm
Location: Sarnia, Ont. Canada

Re: Splitting my rig?

#20 Post by Tom Smit »

I would think that if the copper inductor, not the two red-enameled ones, was standing, then all would be fine.
TomS

tallevan
Posts: 89
Joined: Sun Oct 20, 2019 12:15 pm
Location: London, England

Re: Splitting my rig?

#21 Post by tallevan »

I think Tom is correct.
The copper one upright, two or three cable ties and some hot glue should do it.

A good article on inductor positioning here:
http://www.troelsgravesen.dk/coils.htm

ACUA
Posts: 539
Joined: Sun Sep 25, 2016 6:21 pm
Location: Tucson Arizona

Re: Splitting my rig?

#22 Post by ACUA »

Thanks guys, I shall turn the one coil up on end. Much appreciated :clap:
Advanced Concepts Underground Audio

Post Reply