Lab 15 on sale
-
Hackomatic
- Posts: 400
- Joined: Thu Jun 25, 2009 8:11 am
- Location: West TN
Re: Lab 15 on sale
Looking at the two possible scenarios. . .If the first driver opens before it shorts, the second driver would be preserved. If, however, it shorts before it opens, the second driver could also be damaged.
Dave H
-
bitSmasher
- Posts: 628
- Joined: Fri May 30, 2008 2:55 am
- Location: Sydney, Aus.
Re: Lab 15 on sale
As prompted in another thread... did the T48 and/or T60 get the nod for these drivers?
Noting specs are different:
Noting specs are different:
Re: Lab 15 on sale
Usual rules apply I assume:
In T48: QTS is ONLY JUST too high, everything else in spec (so OK, I'd assume)
In T60: FS is a bit too high; VAS is a little too low; QTS is way too high = bad! (probably)
Notice that there a lot of assumptions here (and we all know about her offspring!)
In T48: QTS is ONLY JUST too high, everything else in spec (so OK, I'd assume)
In T60: FS is a bit too high; VAS is a little too low; QTS is way too high = bad! (probably)
Notice that there a lot of assumptions here (and we all know about her offspring!)
-
Bill Fitzmaurice
- Site Admin
- Posts: 28916
- Joined: Tue May 02, 2006 5:59 pm
Re: Lab 15 on sale
+1. Those specs are skewed for use in a sealed sub, probably for auto sound.escapemcp wrote:Usual rules apply I assume:
In T48: QTS is ONLY JUST too high, everything else in spec (so OK, I'd assume)
In T60: FS is a bit too high; VAS is a little too low; QTS is way too high = bad! (probably)