Titan 48 x3

[Faux127]

Looking good.The way i have learned to avoid wasting wood or cutting panels the wrong way is to draw dotted lines like this (---------)on the width side of the panels so i know not to cut that side.That cuts out ALOT of confusion and i havent cut a panel wrong since i have been doing this.

I buy 4x8 sheets of BB and have the local hardware store cut them into 23x48 sheets for me. (unless I need sides, then 24x48). This means all of my panels are already the correct width. I just have a stack of 23x48's laying on my floor (maybe dewarping?)

I just accidentally cut a baffle in a rhombus shape, rather than a trapezoid, then cut another 2in short for some reason (probably the beer), and also had to recut a mounting ring

^^^there goes a 23 x 52" piece of wood lol.I'm doing 2 of them and i havent wasted a piece of wood or made a bad cut on this build.Marking the width's works for me but i also mark the angle to be cut on the side so when i place the wood on the saw there is no doubt as to which way my angle should be.

I mark the angle on the side as well, but that doesn't protect against an absent minded sawblade

[Faux127]

Been a while since I posted pics, been procrastinating a bunch considering I can't afford all the drivers yet! Here's where I'm at now:

Stack o' Backs

[Rickisan]

Nice progress. Making me wanna get busy with the Table Saw. If you can do it with a circular saw I don't have an excuse.

Just a warning on drinking and power tools. Probably not recommended.

[djtrumptight]

I hope u took into consideration that u have to cut off a 1/2" on those back panels before you cut the hand holds.

[Faux127]

I hope u took into consideration that u have to cut off a 1/2" on those back panels before you cut the hand holds.

Of course

[billkatz]

I hope u took into consideration that u have to cut off a 1/2" on those back panels before you cut the hand holds.

I made that mistake - recovery is that the handles on the bottom don't have room for the quarter-round inside.

[djtrumptight]

I hope u took into consideration that u have to cut off a 1/2" on those back panels before you cut the hand holds.

I made that mistake - recovery is that the handles on the bottom don't have room for the quarter-round inside.

Yeah,i did that too,on my 2nd T48 that i rushed building trying to built it in time for a gig lol.