pair of dr 250's 2510 loaded with flat array

[ketoet]

hello

i finally got around to start building the last set of dr250's i had planned initialy 2 year ago.
back then i purchased the ply for 6 set's and did the rough cut's al in one time on the tablesaw.
when i was building my current set my father in law helped by starting the last pair. only the top
and bottom were cut to size acces panel included . so i had to glue a patch in because
i'm using the newer version of the plans now.
i'm not a great photographer but there are a few pic's of the progress so far.
i know you guy's love speaker pic's.

greetz ketoet

[ketoet]

and some more

[Tom Smit]

Good start.

Did you already put the Tnuts in a couple of years ago as well? You probably noticed your plans that there is a new spacer ring (easier for the next builds )

Must be cold where you are. I noticed the heater on the floor.

[ketoet]

Yes the Tnuts were and i've never had problems with them so i didn't change that.
It was about 5degrees celcuis that day so the heater was very welcome indeed.

Greetz ketoet