Templates for plywood layouts

Message

Knuckle Bones · #1 Post by **Knuckle Bones** » Wed Jun 20, 2007 11:39 am

So I tend to sit and analyze a lot before I start any project. I would like to end up with four DR290s per side....that's a lot of manual layout on plywood. So I think I'm going to get a sheet of ABS plastic, layout the pieces then cut them out and use those as templates to layout the plywood. Anybody else do anything like this or have a better way to do "production line" style work?

#2 Post by **Bill Fitzmaurice** » Wed Jun 20, 2007 1:14 pm

Figure out what you're doing with the first box, that way you'll be sure the templates are correct. I've considered them, but find after doing a dozen or two DRs that laying them out is second nature and I've never bothered. Harley is the 'Henry Ford' here, I'd go by his advise.