Board Buddies

Helpful hints on how to build 'em, and where to get the stuff you need.
Post Reply
Message
Author
rec
Posts: 381
Joined: Tue Jan 30, 2007 1:15 pm
Location: Virginia, C'Ville

Board Buddies

#1 Post by rec »

Not sure if you guys have seen these, but they look pretty cool
http://www.amazon.com/Woodstock-W1104-B ... B0000223VK
My initials are in the view finder of every camcorder (REC)
2xOT12(Deltalite 2512 loaded, w/melded arrays)
2xOT12(Deltalite 2512 loaded, w/flat array) "In Process"
4xT30(24", 4012HO loaded)
1xAT
Top
User avatar
Tom Smit
Posts: 7569
Joined: Sat Jan 05, 2008 1:24 pm
Location: Sarnia, Ont. Canada

Re: Board Buddies

#2 Post by Tom Smit »

I've seen them in a magazine before. One has to remember that, while they can be very helpful, they can't/shouldn't cover up a bad blade or fence alignment.
TomS
Top
User avatar
rbarone
Posts: 71
Joined: Wed Mar 12, 2008 6:53 pm
Location: Port Monmouth, NJ
Contact:
Contact rbarone

Re: Board Buddies

#3 Post by rbarone »

I have a pair with the guide track that have been sitting around the shop.. If want to pay for the shipping from NJ, you can have them n/c.
Top
User avatar
LelandCrooks
Posts: 7242
Joined: Thu May 04, 2006 9:36 am
Location: Midwest/Kansas/Speaker Nirvana
Contact:
Contact LelandCrooks

Re: Board Buddies

#4 Post by LelandCrooks »

Pimp my product here, but I make no cut without this in my hand

http://www.speakerhardware.com/micro-jig-grr-ripper.php

If it's too loud, you're even older than me! Like me.
http://www.speakerhardware.com
Top
Post Reply

Return to “Tips, Techniques and Supplier Links”