Jack 212 build

[MrthaKH]

I have a few more photos that I will upload later, but I didn't document as well as I should have.

Any way... Here is where I stand with my build. Got the cutkit from Leland, and he has been great. Highly recommend.

[jswingchun]

Looks good! Bass guitar cab, I assume?

[MrthaKH]

Indeed so no tweets. I might build a Jack 112 with some sort of tweet setup in the future if I like this enough.

Do you use the tweets on your top cab when used as a bass stack?

[jswingchun]

Do you use the tweets on your top cab when used as a bass stack?

Yes I do. I like a lot of twang in my tone. That said, I have never run without them to see how much difference they make. Could be that I don't really need them, but I like how it sounds so I don't mess with it.

[ian]

You can always EQ them out. Since you build the crossover you even know what frequencies to cut.

[MrthaKH]

I think if I build another cab it would be a Jack 12 with the compression drivers. This 212 should be plenty though as long as I can keep my guitarist from being an idiot about volume.

What crossover do you run with the tweeterless jack?

[MrthaKH]

Clamp city! Should be ready for routing/sanding/duratex by the weekend. Exciting when a box starts coming together.

[MrthaKH]

All I have left is some pieces on the top and bottom of the back to mount the tilt back handle and wheels. Then it is time for the router.

[MrthaKH]

Added some material for the tilt back handle and wheels. Once the PL dries I will route and sand.