HelloI'm building an Omni12
In some joints i used a bit too much adhesive, so there's excess on both sides, on the inside and outside...
i Know that i should scrape away the excess on the outside, but should i do the same on the inside? wouldn't give me a better airtight joint to leave the inner excess untouched?
sorry for the bad spelling jw tnahks
Scraping away the excess?
-
Bill Fitzmaurice
- Site Admin
- Posts: 28916
- Joined: Tue May 02, 2006 5:59 pm
Re: Scraping away the excess?
Leave it.