Will an EP2500 power...?
Will an EP2500 power...?
Hello all, trying to get the system started on a budget. I'm new here, please forgive my lack of knowledge in PA. I may have come across a pair of T30's, but I'm not sure what they're loaded with yet.. Question is will a single EP2500 power: (2) T30's and (1) 2012 loaded OTop? How underpowered would this set up be if they have 3012lfs? 12 LF? S2010? This would only be a temporary solution until I can fund an additional Otop and amp. My apologies for being hypothetical, just really anxious about hearing these beasts. Any advice is much appreciated, thanks!
- Zack Brock
- Posts: 1124
- Joined: Sun Oct 07, 2007 1:06 am
- Location: Northeast Florida
- Contact:
Re: Will an EP2500 power...?
Yes. You could power up to four T30's off of one channel of that EP2500 and up to four Otop 12's on the other. You would be near a two ohm load at that point, a little bit higher with the horn's additional impedance. It may not be as loud as you would want but it would certainly work and make decent noise.
Zack Brock
Authorized Builder, Northeast Florida (Greater Jacksonville Area)
WavePulse Acoustics | zackbrock@macpulse.com | http://www.bestbasscabs.com/
Authorized Builder, Northeast Florida (Greater Jacksonville Area)
WavePulse Acoustics | zackbrock@macpulse.com | http://www.bestbasscabs.com/
Re: Will an EP2500 power...?
You are going to need another crossover though. EP2500 doesnt have DSP.
Built:
2x Tuba 30s delta12lf loaded (gone)
4x Otop12 d2512 loaded
8x t48s (18, 18, 24, 24, 30, 30) 3015lf loaded
2x AT (1 mcm, 1 gto 804)
2x SLA Pro (dayton pa6, 6 goldwood piezo loaded)
1x bastard XF208
2x OT212 (delta pro 450a loaded, eminence psd)
2x Tuba 30s delta12lf loaded (gone)
4x Otop12 d2512 loaded
8x t48s (18, 18, 24, 24, 30, 30) 3015lf loaded
2x AT (1 mcm, 1 gto 804)
2x SLA Pro (dayton pa6, 6 goldwood piezo loaded)
1x bastard XF208
2x OT212 (delta pro 450a loaded, eminence psd)