BillFitzmaurice.info

yup it standing 205 cm tall. 5.25" woofer 1.5" neo tweet. cheap dirt local driver made by Sinar Baja.
and it will be curved following CBT laws. it may took ages to complete the project since i'm workingman with 3 kidz..

here is mine:

Hello Just acquired chinese-made contractor table saw, the model is Axminster TS-200. It has very poor rip fence. Once the knob tightened, the fence will be off axis slightly to the right. also the length is only half of the table. I'm leaning toward swapping aftermarket fence. Problem is the cast i...

so mr. Harley how thick is the Gorilla glue? as thick as tooth paste?

those living outside USA may hard to find recommended PL Premium. recently i tried DAP Beat The Nails but it's too thick (like a tooth paste!), difficult to caulk thru joints. I wonder how viscous the PL is? I imagine it's liquid enough to squeeze into joint easily. the DAP has stamped date that is ...

moo/thomas
did you observe the Ciare 12SW dimension will fit in T39? it looks thicker than eminence.

Alan how many watts (electrical source) required to drive those beasts?
I've seen small portable generator there

sorry for dummy question, other than a circular saw, what I need the most: router, or jigsaw, or both for BFD projects? Bill mentioned jigsaw in the plan.
I'm really green in woodworking.

Dave, Right now the only tools that can do much in the phase domain are BSS Soundweb, Dolby Lake, and EAW UX8800, all of which are cost prohibitive for most users on this forum. However in the next few years I fully expect this will change and these tools will be more widespread. Cheers Jeff Jeff, ...

I think you should build a box too...but if your going to do that, why not build an O10 or an OT? By the time you have build one or two of those, you'll be ready to build a Titan. Once you have knocked off a Titan you'll be ready for a DR...and maybe you won't need it. brilliant idea! maybe OT12 fo...

I'm always intimidating to build few of DRs and Titans everytime logging in this forum. Though I realize that all my fingers are thumbs now, I'm more than willing to learn woodworking since my budget is too tight to hire a builder. where to go from here? any web address for distant learning in woodw...