BillFitzmaurice.info

I think I like it. If I put it upside down, itll be pointing right over the shelf at the back seat. Muhahaha. It would work better if it was pointed at the back, or to the side/rear, for max gain. Could do that too. I dont see why I couldnt hurt to try several configurations to find the best positi...

Yeah, rewound alternators suck. The police 200A unit was built from the ground up as a high-output alternator, though. It is almost twice as deep as the civi alt and It has 8 diodes vice the normal 4. The rotor is so heavy they had to put a One-Way clutch in the pulley so when the trans shifts the r...

So, I Im going to need another sheet of BB. I kept going back and measuring. Looking at it some more, measuring some more. Couldnt decide if the TAT would fit. I finally decided to make a mock up of a full width 18" (single 8") TAT. tatspace.jpg I think I like it. If I put it upside down, ...

wallywally wrote:

colt45ws wrote:On the display board end, why didnt you just desolder the contact then solder the ribbon through the vacant holes?

Desoldering 20 pins and getting them all to let loose with out delaminating the traces didn't seem worth the time or risk of damage.

I can see that. Figured there was a good reason.

On the display board end, why didnt you just desolder the contact then solder the ribbon through the vacant holes?

hnuts being hurricane?

The JBL is technically 11.5mm xmax versus the TBs 12mm. woo

I want to hear how getting it installed with just the one access panel works. Its fatter around than the MCM. If you can get it in alright then Ill probably do what you did with just the one, larger, access.

bassmonster wrote:The GTO804 is an eight. It's about double the price of the MCM, but takes more power. Still only a ~$65 eight inch driver though!

Its $50 with free ship on Amazon right now.

I thought I read somewhere it was around 16' was the cut off. Im assuming thats square. Got the Baltic Birch ordered today. Cost me $39.38 for a 1/2x5x5 sheet. This is going to take me longer than I thought due to the missing tools which Ill have to reacquire. They left the table saw so I have that ...

Oooh, okay.
Yeah, I pretty much figured I would be under under utilizing pretty much anything in this size room.

waitaminutewaitaminutewaitaminute.
I thought the SLA Pros were smaller. I dont have the SLA plans yet, so Im just going off the pictures.

Hello All! So, I found this place somehow and Ive been up late doing research on these designs for about a week now. Ive decided Im going to build an A/T for my Crown Vic. This is so awesome! Before, I was going to setup a 10" or 12" sealed unit and need more money for the driver and amp. ...