BillFitzmaurice.info

Maybe not the most exciting thread, but I wanted to document the process from the beginning. Kinda taking a step back and resetting as far as woodworking and sound both go. This is the small steps to start again. Got the sled bottom glued up and trimmed square. Patched some holes and ready for sand ...

I love this thread. I felt like I was the only one that was going against the grain here. I know where you’re at Keryn. First, I will say it seems that Bruce is giving very clear wisdom and advice. At the end of the day, you gotta take it in stride and make a decision. Not against it, but on account...

Just to clarify. The ladder box in the center of the stringers on the table was my setup for holding it in place to secure the small braces. Assembled each box has one side in those grooves and one side overhanging the outside, secured with a screw through it into the end of each stringer. Super lig...

Felt like cutting some wood, so I set out to get started on the right foot in the panel jig section of the plans. Initially planned to build a push sled for my table saw. Always wanted one and thought it’d be an easy start. Found a couple pieces of ply in the scrap pile that looked like good candida...

I did notice that LAB15. Didn’t mention it for fear of, yeah, we all see it. lol. Nice subtle touch. Very professional look.

Do you have a standard of what connection type you will be needing? 1/4” or XLR in and out? The minis dsp seems to be rca in and out if you’re looking at the 2x4. https://www.parts-express.com/Dayton-Audio-DSP-408-4x8-DSP-Digital-Signal-Processor-for-Home-and-Car-Audio-230-500?quantity=1&utm_sou...

Nice. Looks good on a stand. I like it.

As an option it seems the Kabd can easily push a t24 with bp102-4 ohm safely to 20v for a much more impactful experience. This should give the WH6s a little more room to breath and less bottleneck to get more out of them and remain balanced to the low end. I’m also exploring input output options on ...

Been also researching Etsy for that honeycomb-looking grill work that's all the rave now. Will see if I can get any of that for the project. Radian's interest was not in the cheapest functional option. It was acknowledging the trend and cosmetic as a lot of Pro cabinets have begun using this aesthe...

Hey Keryn, just curious, you put the top hats on your WH6s. What’s your thoughts on an appropriate situation to use them on stands that way?

Hex perforated like this. https://www.onlinemetals.com/en/buy/carbon-steel/22-gauge-0-03-inch-thick-carbon-steel-perforated-sheet-a36-honeycomb/pid/mp-00064382?variant=mp-00064382_12_24_1&gad_source=1&gad_campaignid=21640723615&gbraid=0AAAAADs4Iv0VvyuelIzIFMvWSVA71dCFC&gclid=Cj0KCQjw...

I’m not seeing anything I’d consider cheap, maybe $30-50 per cab. Depending on the sheets and how you can cut it. Most seems to be raw carbon steel and will need painted. Didn’t search Etsy or Amazon real good. Just ended up with a lot of industrial type distributors. Watch the material carefully, t...

That’s sweet. So you can use the same mic. I like that.