BillFitzmaurice.info

At the bottom of the front panel (panel 11), would it have a negative effect on the horn section if had cut out that are shaped after driver access covers? All the exterior panels are made with 18mm BB. I had 18mm BB for about 7 years and was starting to get weathered so I used before it got to far gone. I have a picture of what I am thinking, but sure how to and to this post.

Thanks
Ray

That would make the horn mouth opening too large.

Ok, thank you Bill. I was just thinking about that for looks.

make some faux grills

I was thinking of doing that.
Right now I am dealing with a 120 Hz room mode. That I did not have when using aT45 and a pair of KLH 5's.

Pictures of finished Davids

Great job!
How do they sound?

They sound amazing, very detailed but not harsh. In am using GR research m130 midrange, Radian planar ribbon tweeter and a Tang Band W8-740P subwoofer. For the crossover I a use Sublime Acoustics K231 active crossover at 80 hz and 3K hz. At 200 hz I was getting a loud room mode at 120 hz. I want to try try a 100 hz crossover but have not order that board yet.

I made the mid tweeter panel an exterior panel so I can try different driver combinations.