Page 1 of 1
T48 Setup
Posted: Fri Sep 27, 2024 6:25 pm
by Keryn O'Shea
Good morning,
I hope you guys are doing well,
would 6xT48s be able to be deployed in these configurations successfully outdoors when roadies or a forklift are unavailable for V-Plating?
https://www.prosoundweb.com/a-practical ... -arrays/2/
I'm yet to learn how to use delay. Thanks Seth, for posting this info originally
Re: T48 Setup
Posted: Fri Sep 27, 2024 9:01 pm
by Bill Fitzmaurice
Those patterns are with wide arrays with separated cabs. They don't apply with closely placed cabs, which act as a single source.
Re: T48 Setup
Posted: Sat Sep 28, 2024 3:00 am
by Seth
Keryn O'Shea wrote: ↑Fri Sep 27, 2024 6:25 pm
Good morning,
I hope you guys are doing well,
would 6xT48s be able to be deployed in these configurations successfully outdoors when roadies or a forklift are unavailable for V-Plating?
https://www.prosoundweb.com/a-practical ... -arrays/2/
I'm yet to learn how to use delay. Thanks Seth, for posting this info originally
I've always wanted to do firsthand testing of all that stuff, but have never had that many subs at my disposal.
Re: T48 Setup
Posted: Sat Sep 28, 2024 2:54 pm
by Keryn O'Shea
Bill Fitzmaurice wrote: ↑Fri Sep 27, 2024 9:01 pm
Those patterns are with wide arrays with separated cabs. They don't apply with closely placed cabs, which act as a single source.
Ok, thank you Bill. What number of T48s would be considered a wide array when separated?
Re: T48 Setup
Posted: Sat Sep 28, 2024 3:09 pm
by Bill Fitzmaurice
Don't separate them, it only causes problems.
Re: T48 Setup
Posted: Fri May 23, 2025 9:39 pm
by Keryn O'Shea
Bill Fitzmaurice wrote: ↑Sat Sep 28, 2024 3:09 pm
Don't separate them, it only causes problems.
Roger that.
However If l had to separate the cabs to cover a wide audience, is this setup per side asking for more trouble?
It would be convenient to have two platforms at different heights to stack the mains on, without needing scaffolding or ladders.
Re: T48 Setup
Posted: Sat May 24, 2025 7:18 am
by Bill Fitzmaurice
That's OK.
Re: T48 Setup
Posted: Sat May 24, 2025 4:10 pm
by Keryn O'Shea
Excellent! Thanks Bill
