Page 1 of 1
table tuba
Posted: Sun May 07, 2023 10:00 pm
by mino00
Re: table tuba
Posted: Sun May 07, 2023 10:08 pm
by mino00
https://www.parts-express.com/Dayton-Au ... H5EALw_wcB
how a bout this one compare to the above speaker.
thanks
Re: table tuba
Posted: Sun May 07, 2023 10:32 pm
by Grant Bunter
Both those drivers aren't in the plans as recommended.
Go to PE and search for Dayton Audio DCS205-4, which is a recommended 8" driver, and sells for $75.
If you want a 10" driver, the Dayton DCS255-4 is a recommended driver, at $99...
Re: table tuba
Posted: Sun May 07, 2023 10:56 pm
by mino00
Thanks for quick response on the other thread Biil recomended Dayton Audio LS10-44 10" Low Profile Subwoofer Dual 4 Ohm , May be i m wrong
thanks
Re: table tuba
Posted: Mon May 08, 2023 3:00 am
by Grant Bunter
mino00 wrote: ↑Sun May 07, 2023 10:56 pm
Thanks for quick response on the other thread Biil recomended Dayton Audio LS10-44 10" Low Profile Subwoofer Dual 4 Ohm , May be i m wrong
thanks
The two I put up are certainly in my (now very old) plans.
If Bill has said yes to something, it's good.
The LS10-44 is a dual voice coil variant though.
So it's going to be hard to make that 4 ohms if that's what you're aiming for.