Page 1 of 1
Plan Errors
Posted: Tue Oct 23, 2018 2:04 pm
by mj90210
Preface: I am not trying to be Poindexter type and I didn't want to contact Mr. Fitzmaurice via email.
Where should I comment or post about errors in plans that I have found?
Thanks
Re: Plan Errors
Posted: Tue Oct 23, 2018 2:47 pm
by Bill Fitzmaurice
Post it in the forum for the speaker, then we'll tell you why it's not an error.
It does happen, but usually is found and fixed within a fairly short period after the plans are released.
If you did email me I probably wouldn't see it anyway. Only personal emails get past the screening process. Besides, if there is an error that's something that should be known by everyone of interest.
Re: Plan Errors
Posted: Tue Oct 23, 2018 4:25 pm
by mj90210
10-4!
Re: Plan Errors
Posted: Tue Oct 23, 2018 5:46 pm
by himhimself
gotta say, plans are pretty darn accurate across the board. However, panel jig word doc, page 5. Illustration is correct, but plans say 2 x 19 inch end cap. Should be 2 x 10. Just in the spirit of continuous improvement
