Page 1 of 1
Anyone With Experience w/ this Amp?
Posted: Fri Jan 02, 2015 1:10 pm
by ripNdeb
http://www.sweetwater.com/store/detail/ ... Mgod7zUAMQ
It 'claims' 440W X 4 @ 8Ω
I'm looking to run my tops, two OTop 112s w/ 3012HOs on two channels (stereo) and have two other channels for monitors. Subs, so far, are two 20" T39s - two more in the works - and run off an IPR 3000.
Re: Anyone With Experience w/ this Amp?
Posted: Fri Jan 02, 2015 1:20 pm
by BrentEvans
It works. I put one in an install recently and I was pleasantly surprised. It clips super nasty (typical Behringer amp) but up until clip it's decent.
This is not an endorsement of the amp or company... just an observation.
As with all things Behringer (and other cheap Chinese brands), it should be treated as a disposable purchase. Expect the warranty period and no longer.
Re: Anyone With Experience w/ this Amp?
Posted: Fri Jan 02, 2015 1:49 pm
by ripNdeb
thanks Brent. Do you think it'll clip before it reaches my OTops potential? 440W @ 8 ohms per channel; so, say, half that 220 realistically (Behringer specs evaluated) , should be about right? I'm not looking for max SPL, just good quality.
Re: Anyone With Experience w/ this Amp?
Posted: Fri Jan 02, 2015 2:43 pm
by BrentEvans
They'll work fine for that. I limited them with the X32 output limiters just below clipping and they sound fine, even on sub duty at 4 ohms. No real reason to limit to 1/2 PE of the drivers unless you just want to... they'll complain before they're damaged.
The Nu4-6000 is hard to beat for the price, but I still prefer the IPRs.