BillFitzmaurice.info

Im supposed to pick up one tomorrow morning that i will be using to power 2 and sometimes 4 TITAN48's for $400,good deal or not ?

Or i can get the QSC PLX 3002.

Nevermind,they both have back to front cooling and my Crown XLS has front to back cooling.

So,how would a crown XLS 2500 work for T-48's from anybody's experience ?

Then again,i have been using a Peavey2000 amp with my system without any problems,its not in the same rack with my Crown and there is a empty rackspace in the Peavey rack,hmmm.

djtrumptight wrote:So,how would a crown XLS 2500 work for T-48's from anybody's experience ?

Not with 3015s. Just not enough headroom in my opinion. I tried it on my T39s, but didn't like how quickly it ran out of room. I went with bridged 1500s instead. Never hit the red with 'em.

I may just go with that QSC PLX 3102 and see how it works out.If i dont like it at that price i can recoup my money.I did spy a GX7 on E Bay and no one has bidded on it,its at $300 and no one has bid on it yet.

djtrumptight wrote:I may just go with that QSC PLX 3102 and see how it works out.If i dont like it at that price i can recoup my money.I did spy a GX7 on E Bay and no one has bidded on it,its at $300 and no one has bid on it yet.

You can separate the crown and QSC in the rack and be ok......just put one on top and one on bottom....as long as it a tall rack.

The GX7 is a good amp too.

Cool.I'm hoping i can get it too,that would be beautiful to add that and have my whole hook up in 1 SKB plastic rack,add some casters to it and have a lightweight lift up lift down/build a ramp,roll up roll down.Carrying this Peavey2000 in a case is getting to be too much.I have 4 nice sized casters,i wonder why i never thought to put them on that amp rack