Page 1 of 1
4 25" lab12 loaded T39's and new PA+
Posted: Fri Dec 30, 2011 11:15 pm
by biggerrigger
Can anyone give me the ruff shake down of this unit with these subs. I am all ready setup at my venue and will have 250 people here at 5pm on Sat. I have my X-over figured out 40-100 24bd LW and 100-up to my B215D powered mains. But I have no idea how to set the limiter on this unit. PLEASE HELP.
Re: 4 25" lab12 loaded T39's and new PA+
Posted: Sat Dec 31, 2011 1:33 am
by Tom Smit
Is that the DRPA+?
I can't say exactly for sure, but...disconnect all cabs from the amps. Turn up amps full. Apply full signal from your board to your limiter. Adjust limiter so that the A.C. voltage coming out of the amps is below 50 volts for the T39. Also, read this
http://www.dbxpro.com/forum/viewtopic.php?f=61&t=959