BillFitzmaurice.info

With out further a due!

http://www.youtube.com/watch?v=lW6UmYWnx_E

Be very careful about running those with the access cover off, as the pressure can cause the cone of the driver to shred. Also, from what I could see, the access panel gasket area is not there, albeit its not that hard to install at this part of assembly. But it sounds great. Just wait till you seal them up, and throw some good power to them. Puts a smile on my face everytime.

I would put them outside are re-record this. The mic is so distorted it's not doing any justice.

I'm in awe lol... i will take that note thanks for the heads up, i'll get those panels on before they are ran again! Thats flatlined to with just a cut off... Gotta get into eqing some songs sound literally breath taking others need further eq

When you do it again, turn down the volume really, really low so that the mic won't distort. It must have sounded awesome where you were, but the mic didn't like it at all! Before you post again, listen to the recording first so that it too, will sound first class like your subs.