Page 1 of 1
2 or 4 T39s w/ 3012s - is the XTI 4000 best?
Posted: Thu Apr 21, 2011 12:24 pm
by TimeWarp
What amp do you recomend for running 2 or 4 T39s w/ kappalite 3012lf drivers? I was thinking about a XTI 4000 but should others be considered?
Re: 2 or 4 T39s w/ 3012s - is the XTI 4000 best?
Posted: Thu Apr 21, 2011 12:51 pm
by bzb
XTi 2000 will power 4 of them without issue.
XTi 4000 will power 3 or 4 (if you want to risk running at ~2.5ohm) on one channel leaving the other channel open for your tops.
Re: 2 or 4 T39s w/ 3012s - is the XTI 4000 best?
Posted: Thu Apr 21, 2011 1:29 pm
by jswingchun
bzb wrote:XTi 2000 will power 4 of them without issue.
+1
I run two T39 3012lf on one side of an XTi2000 now. When I build the other two, they will go on the other side of that amp.
Re: 2 or 4 T39s w/ 3012s - is the XTI 4000 best?
Posted: Thu Apr 21, 2011 2:20 pm
by James R
I run 4 T48's on a XTI 4000
Re: 2 or 4 T39s w/ 3012s - is the XTI 4000 best?
Posted: Thu Apr 21, 2011 2:57 pm
by imnotded
I use a QSC RMX 2450 for 4 T39s. Mostly because I have had it for a long time and didnt want to buy another amp. I would get an XTi 2000 though if I needed an amp and processing.
Re: 2 or 4 T39s w/ 3012s - is the XTI 4000 best?
Posted: Thu Apr 21, 2011 5:07 pm
by netwerks
I run 4x T39 3012lf on one channel on a 4000 all the time, I just don't run them extra hard. Three on one channel will purr like a kitten and if you set the limiter @ -6db in the dsp you will be right @ 53v if summing the input to mono.
Re: 2 or 4 T39s w/ 3012s - is the XTI 4000 best?
Posted: Fri Apr 29, 2011 5:42 am
by NCcrashman
James R wrote:I run 4 T48's on a XTI 4000
I bet it THUMPS too!!
Re: 2 or 4 T39s w/ 3012s - is the XTI 4000 best?
Posted: Fri Apr 29, 2011 6:40 am
by netwerks
NCcrashman wrote:James R wrote:I run 4 T48's on a XTI 4000
I bet it THUMPS too!!
Not as hard as 6 or 8
