T60 with a 40hz test tone peaking my SPL meter
Posted: Sat Mar 26, 2011 11:47 am
My meter won't go high enough to measure this unfortunately. The meter just flashes 'over' when it gets above aboit 127dB.
Regards, Ben
BillFitzmaurice.info
Loudspeaker Design
https://billfitzmaurice.info/forum/
T60 with a 40hz test tone peaking my SPL meter
Page 1 of 1
Re: T60 with a 40hz test tone peaking my SPL meter
Posted: Mon Mar 28, 2011 3:23 am
Try stepping back 100m and repeating
Regards, Ben
Regards, Ben
Re: T60 with a 40hz test tone peaking my SPL meter
Posted: Mon Mar 28, 2011 3:24 am
Ahhh, is that how it's done.
Re: T60 with a 40hz test tone peaking my SPL meter
Posted: Mon Mar 28, 2011 3:32 am
nice. more vids!
Re: T60 with a 40hz test tone peaking my SPL meter
Posted: Fri Apr 22, 2011 4:03 pm
that sound is brutal.....
Re: T60 with a 40hz test tone peaking my SPL meter
Posted: Sun Apr 28, 2013 12:47 am
Specs on the T60? As in how wide / is this a 12/15 loaded? Corner? How far was the mic from the sub? What's the max output you can get at 25 Hz? I'm sure that would be fun to try.
Re: T60 with a 40hz test tone peaking my SPL meter
Posted: Sun Apr 28, 2013 1:39 am
+1 but not at exactly 100m.ben.in.salzburg wrote:Try stepping back 100m and repeating
Regards, Ben
You lose 6db for each doubling of distance, so you can use that to calculate your loss due to distance and arrive at a total at 1 metre.
So, your mike would be at 1, 2, 4, 8, 16, 32, 64, 128m etc
And your reading would be + 0, 6, 12, 18, 24, 30, 36 (etc) dB on what you see on your SPL meter and the corresponding distance.
Hope this helps...
Re: T60 with a 40hz test tone peaking my SPL meter
Posted: Mon Apr 29, 2013 10:57 am
How many volts were you juicing it with ?
?