BillFitzmaurice.info

Hello all, trying to get the system started on a budget. I'm new here, please forgive my lack of knowledge in PA. I may have come across a pair of T30's, but I'm not sure what they're loaded with yet.. Question is will a single EP2500 power: (2) T30's and (1) 2012 loaded OTop? How underpowered would this set up be if they have 3012lfs? 12 LF? S2010? This would only be a temporary solution until I can fund an additional Otop and amp. My apologies for being hypothetical, just really anxious about hearing these beasts. Any advice is much appreciated, thanks!

Yes. You could power up to four T30's off of one channel of that EP2500 and up to four Otop 12's on the other. You would be near a two ohm load at that point, a little bit higher with the horn's additional impedance. It may not be as loud as you would want but it would certainly work and make decent noise.

You are going to need another crossover though. EP2500 doesnt have DSP.