Re: myn's Tuba HT Build Thread
Posted: Thu Dec 31, 2015 7:26 pm
Don't. The amp should be as close as possible to the receiver.milehighassassin wrote:Any thoughts on mounting the Amp to the cutout?
BillFitzmaurice.info
Loudspeaker Design
https://billfitzmaurice.info/forum/
myn's Tuba HT Build Thread
Page 31 of 31
Re: myn's Tuba HT Build Thread
Posted: Sat Jan 02, 2016 10:42 am
Thanks. I'll just build an enclosure for the amp by my receiver.
Now to further complicate this. I assume my enclosure for the amp needs some ventilation. Fan needed or just some vents on the enclosure.
TIA
Now to further complicate this. I assume my enclosure for the amp needs some ventilation. Fan needed or just some vents on the enclosure.
TIA
Re: myn's Tuba HT Build Thread
Posted: Sat Jan 02, 2016 10:47 am
milehighassassin wrote:Thanks. I'll just build an enclosure for the amp by my receiver.
Yes, it's always a good idea to provide venting.milehighassassin wrote: Now to further complicate this. I assume my enclosure for the amp needs some ventilation. Fan needed or just some vents on the enclosure.
TIA
Re: myn's Tuba HT Build Thread
Posted: Sat Jan 02, 2016 11:21 am
This is a build thread. When you have a question not directed to the OP of a build thread you should open a new topic. Since the OP hasn't revisited this thread for well over two years it's now closed.