Page 12 of 12
Re: Titan 48x8 build
Posted: Sun Dec 01, 2013 2:17 pm
by Five9teen
Just out of curiousity, are the holes in your access panel drilled large enough, so that the screws/bolts you are using spin freely enough allowing them to just dig into the flange and not "thread" thru the access panel. Also, tighten them in an alternating pattern, a little at a time.
Re: Titan 48x8 build
Posted: Sun Dec 01, 2013 9:43 pm
by Tom Smit
Five9teen wrote:Just out of curiousity, are the holes in your access panel drilled large enough, so that the screws/bolts you are using spin freely enough allowing them to just dig into the flange and not "thread" thru the access panel. Also, tighten them in an alternating pattern, a little at a time.
+1