Re: v3 subs
Posted: Fri Nov 23, 2012 1:17 am
Although I get the feeling OP isn't a native English speaker, it's not like other languages don't use sentences and paragraphs.
I would be very wary of replacing with anything other than the original equipment driver unless you can get the Thiele-Small specs for it and compare possible substitutes.
Not knowing the excursion limit of your replacemnt driver is a problem but you can probably infer it from xmax and thermal rated power as we do on odd drivers for our subs. Perhaps B52 would help you out too.
Since you don't need sub 40hz you may as well highpass there. This will lessen the chances of overexcursion. Setting the limiter on your processor for something conservative would help too.
Reconing may not be timely enough by the sounds of it.
I would be very wary of replacing with anything other than the original equipment driver unless you can get the Thiele-Small specs for it and compare possible substitutes.
Not knowing the excursion limit of your replacemnt driver is a problem but you can probably infer it from xmax and thermal rated power as we do on odd drivers for our subs. Perhaps B52 would help you out too.
Since you don't need sub 40hz you may as well highpass there. This will lessen the chances of overexcursion. Setting the limiter on your processor for something conservative would help too.
Reconing may not be timely enough by the sounds of it.