Loudspeaker Design
https://billfitzmaurice.info/forum/
I don't know if its different88h88 wrote:Is your DEQ different to mine? Mine only goes up to 120db and it's been at 117.5 with only a pair of OT12s and T39s.
Nice setup though, I need to look into getting a custom rack assembled.
I wouldn't use a holesaw. They don't cut an exact size hole because they wobble slightly as they cut.Grant Bunter wrote:My problem is making a 24mm hole quickly. Finding a 24mm/ 15/16" metal hole saw is a PITA, or the reamers required to get it there from some nearby store. I have a 25mm hole saw and a 23mm spade bit (with a quick bit of filing this is a better option for my WH8's as the 25mm leaves a slight gap, ie not sealed, other than my new best friend, holt melt glue).byacey wrote:You could probably retrofit Speakons in place of the XLR outputs on the Jands Power amps. At the very worst, you'll have to open up the hole to a 15/16" or 24mm if the old style male XLRs were used; they only required about a 3/4" hole. While you're at it, provided you never run these in bridge mode, you could flip the phase on wiring to the output jacks, and you're done.
I've done so many of these that I bought a 15/16" chassis punch; it's expensive, but it lasts for years if you keep the threads oiled.
I have one of the stepped bits....I built a couple of rack panels with 'em. Kinda' messy and you have to be careful that you don't go too far and make too big of a hole - but still cheap and functional.byacey wrote: