Page 2 of 2
Re: Dueling TAT build...
Posted: Tue Oct 18, 2011 11:35 pm
by Tom Smit
Gregory East wrote:It's my best guess. The amp isn't turned up very far as "tops" are 16W drivers. Should be 130W bridged @ full noise.
That is at 4 ohm, the BAT is 8, so therefore, 65 watts
Re: Dueling TAT build...
Posted: Tue Oct 18, 2011 11:48 pm
by Gregory East
Amp has 65W per channel at 4 ohms, 2 channels bridged into 8 ohms, so 130W available I believe. But the attenuator is way down.
Sorry about the hijack, point is it makes lots of noise on very little juice.
Re: Dueling TAT build...
Posted: Wed Oct 19, 2011 7:57 pm
by Tom Smit
Gregory East wrote:
Sorry about the hijack
Me too.
