Dueling TAT build...

Post your build odyssey here.
Post Reply
Message
Author
User avatar
Tom Smit
Posts: 7569
Joined: Sat Jan 05, 2008 1:24 pm
Location: Sarnia, Ont. Canada

Re: Dueling TAT build...

#16 Post by Tom Smit »

Gregory East wrote:It's my best guess. The amp isn't turned up very far as "tops" are 16W drivers. Should be 130W bridged @ full noise.
That is at 4 ohm, the BAT is 8, so therefore, 65 watts
TomS
Top
Gregory East
Posts: 3495
Joined: Sat May 13, 2006 9:56 pm

Re: Dueling TAT build...

#17 Post by Gregory East »

Amp has 65W per channel at 4 ohms, 2 channels bridged into 8 ohms, so 130W available I believe. But the attenuator is way down.

Sorry about the hijack, point is it makes lots of noise on very little juice.
BAT10, Bad Auto Tuba. Reverse folded TAT to fit JBL 1014D, 350W driver, voltage limit unknown.
Top
User avatar
Tom Smit
Posts: 7569
Joined: Sat Jan 05, 2008 1:24 pm
Location: Sarnia, Ont. Canada

Re: Dueling TAT build...

#18 Post by Tom Smit »

Gregory East wrote: Sorry about the hijack
Me too. :cry:
TomS
Top
Post Reply

Return to “Build Threads”