DIY Panel Saw Plans

Message

mudbwetdirt · #1 Post by **mudbwetdirt** » Tue Oct 30, 2007 1:08 pm

I wasn't sure where to post this but I stumbled on Panel Saw Plans if you are handy you can build one. First download DeltaCad free to use for 45 days then download PanelSawPlan.zip. Unzip and open the files then print them out. The zip is at -
http://www.uploadburner.com/?d=0C6C820A1
When you get to the site go down past the adds enter the code click submit wait like 15 seconds and download the zip. It looks like a nice setup to cut plywood with a circular saw. Looking at the plans you may need to make it a bit taller to cut 5 X 5

Mark Coward · #2 Post by **Mark Coward** » Tue Oct 30, 2007 1:11 pm

That link does not work for me

mudbwetdirt · #3 Post by **mudbwetdirt** » Tue Oct 30, 2007 1:16 pm

Mark I think I got the link working, go for it, post if it works

LelandCrooks · #4 Post by **LelandCrooks** » Tue Oct 30, 2007 1:39 pm

Sure that's not copyrighted material? The first page of the doc file says thanks for your purchase. I could not find a copyright notice anywhere though.

I did find the link to the same plans on another forum from 2006.

mudbwetdirt · #5 Post by **mudbwetdirt** » Tue Oct 30, 2007 1:51 pm

I got it from Free woodworking plans but forgot which site. I surfed a bunch of them. You all know how cheap I am and I'm too stupid to steal.
Edit: I found the site again
http://www.woodworkersworkshop.com/cadfiles/jigs.htm