Hello!
New builder here. Me and a friend are going to attempt to build a set of DR200's and we purchased the plans but are a bit confused about how to use sketchup to get the instructions on building the flat array. Does anyone have any suggestions or tricks on using the program or what I am missing?
How to use sketchup
-
- Posts: 6915
- Joined: Mon Nov 28, 2011 11:12 am
- Location: Ilfracombe Queensland Australia
- Contact:
Re: How to use sketchup
Hello and welcome to the forum
Umm the instructions are in the plans, which is the doc or PDF.
I only use sketchup to confirm.
Any, have you worked out how to select, move and zoom yet?
Umm the instructions are in the plans, which is the doc or PDF.
I only use sketchup to confirm.
Any, have you worked out how to select, move and zoom yet?
Built:
DR 250: x 2 melded array, 2x CD horn, March 2012 plans.
T39's: 4 x 20" KL3010LF , 2 x 28" 3012LF.
WH8: x 6 with melded array wired series/parallel.
Bunter's Audio and Lighting "like"s would be most appreciated...
DR 250: x 2 melded array, 2x CD horn, March 2012 plans.
T39's: 4 x 20" KL3010LF , 2 x 28" 3012LF.
WH8: x 6 with melded array wired series/parallel.
Bunter's Audio and Lighting "like"s would be most appreciated...