How do i wire my crossovers for a J112 with piezo array

[izzytoots]

I am having difficulties figuring out how exactly to wire my HP/LP filter for my J112. I have the components that i ordered from leland, and i understand how to wire the low pass and the high pass filter by themselves (the plans explain that well), but I have no idea how to put it all together and finish wiring my speaker. I just finished the cabinet today, and now all i have left is wiring and insulating.

[Tom Smit]

Go ahead and make the filters separate. Run from +1 on the Speakon to the woofer filter +ve, and a separate wire from woofer filter +ve to the tweeter filter -ve. Then run a single wire from -1 on the Speakon to woofer filter -ve terminal, and one more wire from there to the +ve terminal on the tweeter filter input.

[izzytoots]

Thanks I think i have a handle on what to do now. I'll post an update when i finish.

Also, when wiring the crossover, can i solder the inductors and capacitors directly to eachother, or do i need to use other wire? I assume i can directly wire them, but i just want to make sure i don't fuck anything up.

[Tom Smit]

Thanks I think i have a handle on what to do now. I'll post an update when i finish.

Also, when wiring the crossover, can i solder the inductors and capacitors directly to eachother, or do i need to use other wire? I assume i can directly wire them, but i just want to make sure i don't mess anything up.

Yes, they can be soldered directly to each other. And, if you keep the filters separate, it will keep the process simpler and easier to diagnose.

[LelandCrooks]

This shows a physical layout. Except you might reverse the polarity on the array.

[izzytoots]

awesome. Thanks guys.

[Les Webb]

+ 1 for the awesome diagram. Makes much more sense to me this way